Product Details

The AB30A200AC PWM servo drive is designed to drive brushless and brushed type DC motors at a high switching frequency. A single red/green LED indicates operating status. The drive is fully protected against over-voltage, under-voltage, over-current, overheating and short-circuits across motor, ground and power leads.

Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single AC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.

This drive can use quadrature encoder inputs, Hall Sensors, or a tachometer for velocity control.


Metric Toggle
More Information
Product Category Amplifiers - Analog Type
Manufacturer Advanced Motion Controls
Short Description 30-125 VAC (50/60 Hz, 3ph) Input {optionally 40-175 VDC}; 10A continuous / 30A peak
Commutation Trapezoidal
Min Input Supply Voltage (VAC) 30
Min Input Supply Voltage (VDC) 40
Max Input Supply Voltage (VAC) 125
Max Input Supply Voltage (VDC) 175
Max Continuous Output Current (A) 10
Max Peak Output Current (A) 30
Motor System Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)
Operating Mode Current, Duty Cycle (Open Loop), Encoder Velocity, Hall Velocity, Tachometer Velocity
Feedback Hall Effect Sensors, Incremental Encoder, Tachometer
Configuration Panel Mount
Drive Architecture Analog
Series AxCent Series,vendor=Advanced Motion Controls
Setup Manual
Min Operating Temperature (°C) 0
Min Operating Temperature (°F) 32
Max Operating Temperature (°C) 65
Max Operating Temperature (°F) 149
Max Rated Power (W) 2494
30-125 VAC (50/60 Hz, 3ph) Input {optionally 40-175 VDC}; 10A continuous / 30A peak

Sample image only. Product may differ

Product Availability
Usually in Stock: Ships in 5-7 Days. Expedited Delivery Available. Please Inquire.